ZyXEL Communications P-2612HNU-Fx Support Notes page 9

You must first install the TCP/IP software on each PC before you can use it for the
Internet access. If you have already installed the TCP/IP protocol, go to the next
section to configure it; otherwise, follow these steps to install:
In the Control Panel/Network
•
In the Select Network Component Type
•
Add.
In the Select Network Protocol
•
manufacturers, then select
3. TCP/IP Configuration
Follow these steps to configure Windows TCP/IP:
In the Control Panel/Network
•
click Properties
In the TCP/IP
•
Note: Do not assign any arbitrary IP address and subnet mask to your PCs; otherwise,
you will not be able to access the Internet.
Click the WINS
•
Click the Gateway
•
button until there are none listed.
Click the DNS Configuration
•
Click OK to save and close the
•
Click OK to close the Network window. You will be prompted to insert your
•
Windows CD or disk. When the drivers are updated, you will be asked if you
want to restart the PC. Make sure that your Device is powered on before
answering "Yes" to the prompt. Repeat the aforementioned steps for each
Windows PC on your network.
All contents copyright (c) 2010 ZyXEL Communications Corporation.
window, click
windows, select
TCP/IP
window, click the
button.
Properties window, select
configuration tab and select
tab. Highlight any installed gateways and click the
tab and select
TCP/IP
P2612HNU Fx Support Notes
Add button.
windows, select
Microsoft
from the Network Protocols
TCP/IP
obtain an IP address
Disable WINS Resolution.
Disable DNS.
properties window.
9
Protocol and click
from the list of
and click OK.
entry to select it and
automatically.
Remove