Port Forwarding Configuration - ZyXEL Communications P-2612HNU-Fx Support Notes

multimedia applications. This feature is best demonstrated with the NAT port
forwarding feature implemented in the CPE. In a scenario shown in the above
diagram, we have an FTP server installed behind the CPE with an IP assigned by the
local DHCP server (192.168.1.33). How should we configure the P-2612HNU-Fx, so
that the notebook at the WAN site can access the FTP server? The following
step-by-step guide illustrates the setup.
PS: Make sure that NAT is enabled on the WAN interface.

Port Forwarding Configuration

a. Create a port forwarding rule for the FTP server.
1. Go to Network > NAT > Port Forwarding.
2. Select the Service Name, e.g. "FTP".
3. Select the WAN Interface, e.g. "Data_IPTV".
4. Enter the Server IP Address, e.g. "192.168.1.33".
5. Click Add.
The following warning message may pop up:
All contents copyright (c) 2010 ZyXEL Communications Corporation.
P2612HNU Fx Support Notes
27