Rear-Facing Installation; Latch Installation - Britax ADVOCATE User Manual

BRITAX Child Safety, Inc.

Rear-Facing Installation

LATCH Installation

1. Remove the lower
connectors from the
storage slots in the base.
Press the adjuster release
button and pull the strap
to full length. Repeat for
the second strap.
2. Recline this child seat to
position 3 and place rear-
facing on the vehicle seat
(see page 26).
3. Firmly press the lower
connectors onto the
adjacent lower anchors
until a click confirms
attachment.
4. Push the child seat
down while pulling each
lower connector strap to
tighten.
5. Rear-facing installations
can be improved by the
use of the Versa-Tether
(see page 29).
8
a
or
b
Rear-Facing Installation with LATCH
9 Check that all connections are secure and straps are not
twisted.
9 Check that the child seat cannot be moved front to back
or side to side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 Check that the back angle of the child seat is 30° – 45°
1
from vertical (not to exceed 45°) when the car is parked
on a level surface. See "Seat Positions" on page 26.
ADVOCATE User Guide
9