Harness Buckle - Britax ADVOCATE User Manual

BRITAX Child Safety, Inc.
4. Attach the plastic hooks
to the bottom edge of the
child seat.
5. Slide the head restraint
cover over the front of
the head restraint and
attach the hook and loop
fasteners at the back.
Attach the elastic straps
to the rear tabs.
6. Attach the hook and loop
fasteners on the head
restraint cover around the
harness straps.

Harness Buckle

If your child eats and drinks while in the child seat, you will
need to check the buckle periodically and rinse out any
accumulated debris.
Removing the Harness Buckle
1. Lift the cover from the seat
to find the buckle strap
connection.
2. Remove the buckle strap
by turning the buckle
retainer sideways and
routing it out of the front
buckle slot in the child
seat.
38
3. Slide the end of the belly
pad over the foam pad on
the seat.
4. Pull the end of the belly
pad and buckle retainer
out of the slot in the cover
to remove.
5. Turn the buckle retainer
sideways and route the
buckle assembly out of
the belly pad.
Cleaning the Harness Buckle
• THOROUGHLY RINSE the buckle using warm water.
• TEST THE BUCKLE by fastening and unfastening until a
click is heard after inserting each buckle tongue. If clicks
are not heard, repeat the cleaning procedure.
• TOWEL DRY.
• DO NOT:
– Soak
– Lubricate
– Use solvents
– Use soap or household detergents
ADVOCATE User Guide
39