Maintenance; Glass Cleaning - Dimplex PF2325 Service Manual

Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn
the fireplace off and it will not come back on without being
reset. It can be reset by unplugging the unit and waiting 15
minutes before plugging the unit back in.
Once power is restored the unit will start to reset itself.
During this process you will hear repeated beeps and the
Floating Display™ may turn on and off.
CAUTION: If you need to continuously reset the heater,
disconnect power and call Dimplex customer service at
1-888-DIMPLEX (1-888-346-7539).
Battery Replacement
To replace the battery:
1. Slide battery cover open on the back of the remote
control.
2. Install one 3V (CR 2032) battery in the battery holder.
3. Close the battery cover.
Battery must be recycled or disposed of properly.
Check with your Local
cling advice in your area.
(Figure 3)
Authority or Retailer for recy-

MAINTENANCE

WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of fire, electric
shock or damage to persons.
CAUTION: Allow adequate time for the element and
body casing to cool before attempting to clean the unit.
It is suggested that the heater be inspected regularly, for
cleanliness of the fan exhaust and intake grille, to ensure
optimal performance is maintained. The grille can be
cleaned by vacuuming off all dust and dirt.

Glass Cleaning

The front glass is cleaned in the factory during the as-
sembly operation. During shipment, installation, handling,
etc., the front glass may collect dust particles, these can be
removed by dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the glass can be
cleaned with a damp cloth. The glass should be com-
pletely dried with a lint free cloth to prevent water spots. To
prevent scratching, do not use abrasive cleaners or spray
liquids on the glass surface.
Fireplace Surface Cleaning
To remove fingerprints or other marks, the exterior finish
can be cleaned with a damp cloth with a mild detergent.
The surface should be completely dried with a lint free cloth
to prevent water spots .
Servicing
Except for installation and cleaning described in this manu-
al, an authorized service representative should perform any
other servicing.
5