Connections; Power Switch; Operations Of The Ar-Stv; Display - AOR AR-STV Operating Manual

3 Connections

Connect the supplied flexible rubber antenna to the SMA antenna connector on the top of the AR-
STV.
If required, an external antenna may be connected with a SMA connector for the coaxial cable.
Insert the supplied 4 AA size Ni-MH cells into the
battery compartment in the AR-STV.
If the batteries are not yet charged, connect the
DC power supply into the power input connector on
the right side.

4 Power switch

To switch on the AR-STV, slide the power switch on the right side of the AR-STV upward.
4-1 Start-up
After inserting the batteries, switch on the power switch. The LCD displays search screen
and a STA (Status) LED will blink indicating the AR-STV is in the search mode.
4-2 Powering down
To switch off the AR-STV, slide down the power switch.
4-3 Low Battery
When internal battery voltage becomes low, the Low Battery indicator will appear on the LCD
screen. In the meantime, a beep will sound.

5 Operations of the AR-STV

To set or remove the key lock, press the blue button and FREQ.DOWN switch simultaneously.

5-1 Display

This section explains what you can expect to see on the AR-STV
LCD monitor screen.
Once the AR-STV is properly powered up, this display will
appear on the screen:
When this message appears on the screen, all operations of the AR-
STV will quit automatically. Immediately switch off the AR-STV, and
replace all internal battery cells with new ones or charge the supplied
batteries by connecting the DC powers supply. (Charging time approx.
10h)
7