Table of Contents
Advertisement
Step: Select the search frequency step. (Entry range: 2 ~ 10 MHz)
To change the parameter, perform the same procedures as the start frequency entry.
Noise Level: Select the noise threshold level. (Entry range: -30 ~ -80 db min 5 dB increments)
Suggested level:
Run: Select the search bank enable or disable.
To change the parameter, perform the same procedures as the start frequency entry
Video Level: Select the video threshold level. (Entry range: 0 ~ 95 %)
Suggested level:
If the parameter is set to 0, then the AR-STV searches with the noise level setting.
3. To exit from this setting screen, press and hold the MODE key for 3 seconds.
5-2-2 Memory mode
In the Memory mode, you can change the memory channel setting, record images into memory.
To use this function, a formatted SD memory card (not included) must be inserted in the SD slot.
To go into the Memory mode, press the MODE key and REC key simultaneously.
(If no SD memory card is in the slot, a beep will sound and a "SD Card No File" error message
appears.)
Memory mode screen:
75 (for normal search)
0 (for weak signal)
60 (for normal search)
20 (for weak signal)
11
Advertisement
Table of Contents
