Table of Contents
Advertisement
7. Insert the end of the hose through the skimmer
opening and connect the hose directly onto the
automatic regulator valve.
8. Slide the hose protector into position on the
hose to prevent the hose body from rubbing
against the skimmer wall. See Figure 9.
Optional Vacuum Line Installation
Vacuum Line Installation With Automatic Regulator Valve in Skimmer.
We recommend the use of the automatic reg u l ator va l ve to balance water fl ow between Kre epy Kra u ly and
the skimmer. When attaching Kreepy Krauly to a dedicated vacuum line, the automatic regulator valve
should be installed in the skimmer.
Accessories NOT PROVIDED:
Snap-Lock Wall Fitting
(Part #K12500)
45º Hose Connector
(Part #K12078)
1. Turn the pool pump off.
2. Close the main drain and all suction lines, except
the skimmer and the vacuum line to which the
Kreepy Krauly will be connected.
3. Thread the snap-lock wall fitting into the end of the dedicated suction line. Then insert the
male end of the 45° hose connector into the snap-lock fitting. See Figure 10.
w raps of Te flon tape around the thre a d s to ensure easy removal.
4. Place Kreepy Krauly (with the hose and hose weights assembled and attached) into the pool
and allow it to sink to the floor.
section in this installation.
completely filled with water and purged of air.
NOTE: You will have to remove the female/female hose
Continue to feed the hose vertically down into the pool until it is
Figure 9
Top of Skimmer
Hose through
Skimmer
Opening
Automatic
Regulator
Valve
Threaded
Compression
Adapter
(or 2'' Hose Cone)
Figure 10
Snap-Lock Wall Fitting
45° Hose
Connector
Male/Female
Hose Section
Attach
Hose
This End
Thread Snap-Lock
into Dedicated
Suction Line
in Pool Wall
NOTE: Use t wo
Hide quick links:
Advertisement
Table of Contents
