Pool Preparation; Assembly; Ii. Assembly - Kreepy krauly Pool-cleaning system User Manual

I. Preparation Of Your Pool
Before assembling and installing your Kreepy Krauly, your pool should be clean and algae-free so as not
to inhibit the cleaner's traction. If necessary, make the following preparations before proceeding:
1. Chemically balance the pool water.
2. Brush pool and let the debris settle.
3. Hand vacuum thoroughly.
4. Clean filter and pump strainer basket.

II. Assembly

Remove Kreepy Krauly and all of its parts from the box and check to make sure that all components
were included. Refer to Figure 1.
Components Check List
1. Dive float restrictor
2. Kreepy Krauly
3. Locking end clip
4. Roller bumper strap
5. Hose weights
6. Wings
7. Eyeball diverter and outer ring
8. Valve cap
9. Automatic regulator valve
10. Threaded compression adapter
11. Pleated or Starfish seal
1 2 . Hose – 40 ft. total length (not show n )
13. Installation video (not shown)
Step 1. Attach The Wings
Kreepy Krauly's wings snap into place – no tools are needed. Position the wings so you bring the band
around the main body as shown in Figure 2. Slip the wings into the groove in Kreepy Krauly's main
body, then snap the band clamp into place.
Figure 2
Main Body
Figure 1
Wings
Serial Number
For Concrete Pools Only
or