Section 1: Pool Preparation; Sandshark ™ Cleaner Assembly - Kreepy krauly SandShark Installation And User Manual

The following general information describes how to set-up your new SandShark
NOTE: Before setting up this product, read and follow all warning notices and instructions starting
on page ii.
Preparation of your pool
Before you assemble and install your new SandShark
your pool is clean and free of algae. If necessary, make the following preparations before proceeding
Chemically balance the pool water
•
Brush the pool and let the debris settle
•
Hand vacuum the pool thoroughly
•
Backwash and clean the filter and clean the pump
•
strainer basket, (see Figure 1)
Cleaner Assembly
Check Parts
Remove the Cleaner and all of its parts from the box and
check to make sure that all components were included,
(see Figure 2).
■ Pool Cleaner
Short Leader Hose
■
(1 Length, 12 inches)
Hose (10 Lengths, 40 inches)
■
Hose Weights (2)
■
Eyeball diverters (2)
■
Reducer Cone
■
Vac Port Fitting
■
Regulator
■
Regulator Cap
■
■ Flow Gauge
Pool Preparation
™
automatic pool cleaner, you should make sure that
Skimmer
Basket
Pump
Strainer
Figure 1.
Pool Cleaner
Figure 2.
Section 1
™
automatic pool cleaner.
Eyeball
Hose Weights
Regulator
Vac Port Fitting Regulator
™
SandShark Installation and User's Guide
1
:
Reducer
Cone
Guage
Cap