Connecting The Antennas; Preparing The Remote Control - Kenwood VRS-7200 Instruction Manual

Setting up the system

Connecting the antennas

The broadcast reception cannot be made unless the antennas are
connected. Connect the antennas correctly as instructed below.
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as possible
from the receiver, TV set, speaker cords and power cord, and adjust the
direction for best reception.
AM antenna terminal connections
1 Push lever. 2 Insert cord.
FM indoor antenna
The supplied indoor antenna is for temporary use only. For stable signal
reception we recommend using an outdoor antenna. Disconnect the
indoor antenna when you connect one outdoors.
FM antenna terminal connections
Insert the connector
(For the U.S.A. and Canada)
FM outdoor antenna
Lead the 75Ω coaxial cable connected to the FM outdoor antenna into the
room and connect it to the FM 75Ω terminal.
For the U.S.A. and Canada
FM indoor antenna
For Europe and Australia
Use an antenna
adaptor
(Commercially
available)
3 Release lever.
(For Europe and Australia)
Antenna adaptor
FM indoor antenna
Attach to
the stand
White
Black
AM loop antenna
FM outdoor
antenna

Preparing the remote control

Loading the batteries
1 Remove the cover.
3 Close the cover.
¶ Insert two AAA-size (R03) batteries as indicated by the
polarity markings.
Remote control operation
When the STANDBY indicator is lit, the power turns ON when you press
the RECEIVER on the remote control. When the power comes ON,
press the key you want to operate.
Operating range
(Approx.)
6m (20 ft.)
RECEIVER
¶ When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
The remote control unit is designed so that the setup codes stored in
it are saved even after the batteries are removed for replacement.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
2 Insert the batteries.
Remote sensor
15
EN