Re-Assignment Of Rear Panel Jacks - Kenwood VRS-7200 Instruction Manual

Preparing for playback
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the "CLIP" indicator
will lights up. Adjust the input level.
1 Press the RCV MODE key on the remote control unit to
set it to the receiver control mode.
2 Press the SOUND key.
3 Use the MULTI CONTROL @ / # (or the @ / # keys) to select
"INPUT", and press the ENTER.
4 Use the MULTI CONTROL % / fi (or the % / fi keys) to
adjust the input level.
÷ The adjustment mode is displayed for approximately 20
seconds.
÷ The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
÷ You can store a separate input level for each input selector.
5 Press the SOUND key again to return to the input
indication.

Re-assignment of rear panel jacks

The assignment of the input selector positions to the digital audio and
component video input jacks can be changed as desired.
1 Press the SETUP key.
2 Use the MULTI CONTROL @/ # (or the @/ # keys) to
select "ASSIGN." on setup displays, and press the ENTER.
3 Use the MULTI CONTROL @/ # (or the @ / # keys) to
select "DIGITAL" or "COMPONENT", and press the ENTER.
1 "DIGITAL": Select to change the assignment of the digital
audio input jacks of the receiver.
2 "COMPONENT" : Select to change the assignment of the
component video input jacks of the receiver.
3 "EXIT": Press the ENTER again to return to the main
setup displays.
22
EN
4 Press the MULTI CONTROL @/# (or the @/# keys) to select
the input jack name and then press the MULTI CONTROL
%/fi (or the %/fi keys) to select the input selector position.
When the "DIGITAL" has been selected:
Input jack selection (@/#)
1 " COAX1 "
2 " COAX2 "
3 " OPT1 "
4 " OPT2 "
When the "COMPONENT" has been selected:
Input jack selection (@/#)
1 " CPNT1 "
2 " CPNT2 "
Use the following table for your memorandum.
Jack name
COAX1 (DVD)
COAX2 (VIDEO 2)
OPT1 (VIDEO 1)
OPT2 (AUX)
COMPONENT VIDEO INPUT
IN1 (DVD)
COMPONENT VIDEO INPUT
IN2 (VIDEO 2)
÷ It is not permitted to assign two input selector positions for
one input jack.
5 Repeat step 4 until you have assigned the desired jacks
to the desired input selector positions.
6 Press the ENTER again to return to the main setup
displays.
Input jack Input selector
Input selector position (%/fi)
1 " DVD "
2 " V2 "
3 " V1 "
4 " AUX "
Input selector position (%/fi)
1 " DVD "
2 " V2 "
3 " V1 "
Assigned input selector