Table of Contents
Advertisement
4
Start recording.
Press the MEMORY
REC key again to enter
record mode.
* A message [Don't remove
MEMORY CARD] is scrolled.
5
Start playback of the Kenwood
digital audio player.
* If the dedicated cable is not used for the
connection, start playback on the connected
Kenwood digital audio player.
If the memory card contains a folder named AL_Z90
or higher, a message [CHECK REFRESH] is displayed
Hint
and recording cannot be started. In this case, it
is required to rearrange the folders by means of
refreshing. (See page 52.)
When recording completes:
The memory card stops and a message
[DATA WRITING] is displayed.
* Do not switch the system OFF or apply shock or
vibration to it while [DATA WRITING] is displayed.
* If the power to the system is shut off before [DATA
WRITING] disappears, the recorded data will be lost.
These are the operating procedures.
Indicates a step using the
remote control unit. Press
the remote control unit keys
to perform this operation.
* Steps with which both
using either the remote control unit or main unit.
Dividing music during recording
During recording from the TUNER,
AUX or D.AUDIO source to a memory
card, the recorded music file can be
divided into multiple music files by
manually entering a track mark (music
division mark). Each press of the key
or knob creates a new music fi le from
that point.
Press at the point you
want to divide the music.
* The track marks can
also be entered
automatically. (See
page 59.)
If the audio recorded is distorted
or too low
Adjust the recording level. (See page 58.)
When the memory card becomes
full before completion of recording:
A message [STOP REC No Capacity]
is displayed. Erase the unnecessary
music fi les before retrying recording
from the beginning. (See page 36.)
Indicates a step using the
main unit. Press the main
unit keys to perform this
operation.
and
are shown can be performed
33
Display during or after each
operation
The text represents the characters
displayed as the character information
on the display by enclosing them in [ ].
Example: Select [INTRO SCAN].
* The display illustrations in this manual
have been drawn exclusively for use
in explanation. They may differ from
the actual views of the display.
Supplementary tips on
operations
Items and operations related
to the above operation
23
Advertisement
Table of Contents
