Miele CM 5100 Operating Instructions Manual page 59

Message
The following
appears in the
display, even
though the drip tray
is empty:
EMPTY THE
DRIP TRAY
You can hear the
noise of the pump
and the following
appears in the
display:
FILL WATER
CONTAINER AND
PLACE IN THE
MACHINE
Dispensing stops
and the following
appears in the
display:
PROCESS STOPPED
WATER CONT. EMPTY
Possible cause and remedy
The drip tray is not sitting correctly.
^ Push the drip tray into the coffee machine until it clicks
into position.
or
The metal contact discs are dirty.
^ Clean the discs and then dry them thoroughly.
or
^ The drip tray sensing mechanism is not working.
^ Switch the coffee machine off and then back on again
using the master switch.
If the fault message appears in the display again,
^ Call the Service Department.
The coffee machine is attempting to draw in water although
the water container is empty. Air is present in the pipework.
^ Fill the water container with cold tap water.
SYSTEM FILLING UP - START will appear in the display.
^ Then press the OK button.
There is not enough water in the water container.
^ Fill the water container with fresh tap water and replace it
in the machine.
^ Then press the OK button.
The following message appears in the display: CONTINUE
DISPENSING - YESB.
^ Press the OK button to continue dispensing,
or select NO to cancel preparation.
Problem solving guide
59