AMX Tango Operation/Reference Manual page 57

FIG. 68
20-Pin Connector and Ribbon Cable
6.
Replace the two screws that were removed when the Tuner Option cover plate was removed to secure the
faceplate of the DAS-AMFM to the controller.
FIG. 69 provides a view of the inside of the controller, with two tuners installed.
FIG. 69 Dual Tuner Cable Connection



7.
On units with green Interface Boards only: Connect the supplied cable from the tuner to the Interface
Board as shown in FIG. 70.
New tuner connection
FIG. 70
Connection of the cable to the left-side pins on the back of the interface board.
The 3-wire end connects to the open pins on the Interface Board with the white wire
pointed up.
Tango / Mi-Series Audio Controllers
2
3
While it is recommended that you use the Slot 2 connector on the ribbon cable to connect the Tuner
installed in Slot 2 (in this case, the DAS-AMFM Tuner), the ribbon cable itself does not determine
which Tuner is Tuner 1 and Tuner 2.
This determination is set by the jumper settings on each Tuner Module (see "Dual Tuner
Installation Instructions" above).
Therefore, it is not required that the connections indicated in FIG. 66 are followed exactly, as long
as the Tuner Jumper Settings are set correctly for each Tuner Module installed.
1
1 - Ribbon Cable
2 - Tuner 2
3 - Tuner 1
Tuner Modules
45