Page 3
Montaje - Seguir la secuencia numérica. Montagem do exaustor - Seguir a ordem de sequência numérica. Montage de la hotte - Suivir la sequence à numeros Montaggio della cappa - seguire la sequenza dei numeri Mounting the hood - Follow the numerical sequence Montage der Dunstabzugshaube - Sich an die Ziffernfolge halten.
If the plug is not accessible once it has been Use: Two systems are available inserted in the socket, it will however be necessary to fit an approved bipolar switch with Exhaust mode (S) a minimum contact opening of no less than 3mm. Vapours are extracted outside through an Appliance without plug exhausting pipe that is affixed to the connection...
buttons: after 3 seconds LED 5 will stop flashing Maintenance and the device will be switched off. Before performing any maintenance operation, 6 - Intensive speed LED isolate the hood from the electrical supply by 7 - Intensive speed ON switch switching off at the connector and removing the This speed should be used when the connector fuse.
button 1 for about 3 seconds until you hear the acoustic signal (beep). The LED 5 will now stop flashing. To fit the carbon filter - Fig. 2: 1. Disconnect the hood from the electricity. 2. Remove the metal filters. 3.