Attaching The Dc Power Cable - Tesla TI15014-120-240 User Manual

4.3 – Attaching the DC Power Cable
CAUTION
Before wiring up the DC Output Cable, make sure both the ac line voltage and the Quick Disconnect
Connector Cable are disconnected. The TI150 may have a residual charge. Allow approximately 5 minutes
for complete discharge. The wires coming out of the dc output cable are internally connected as illustrated
in Figure 3.4.1. Connect the "red" ring terminal or alligator clamp of the TI150 DC Quick Disconnect Cable
Assembly to the positive terminal of the battery. This is the terminal marked with the + symbol. Next
connect the "black" ring terminal or alligator clamp of the TI150 DC Quick Disconnect Cable Assembly to
the negative terminal of the battery. This is the terminal marked with the - symbol.
Figure 4.3.2– Model numbers and corresponding dc output voltages
Plug the ac line cord into the unit, then plug the ac line cord into a 120 or 240 power source. Once the unit
has been plugged in, the Quick Disconnect can be reattached.
TI150 Series Battery Charger/Conditioner
Unit damage may occur if the DC output cable is im-
properly wired. Make sure voltage is appropriate for
your specific model. See model numbers below in
Figure 4.3.2
Red- Positive
Black - Negative -
Figure 4.3.1 – Quick Disconnect Connectors and color coding
TI15014-120-240
TI15028-120-240
Pre-Operation Procedures
+
14.25 Vdc @ 20 A
28.5 Vdc @ 10 A
4
13