Playing Music - Kenwood C-V750 Instruction Manual

Playing music

The following procedure allows to play a CD or cassette
tape.
22
Preparations
÷ Connect components as described in "System connection".
÷ Complete "Setup of the Graphical Remote Control (GRC) unit".
1
Press the ON/STANDBY key to ON.
Main unit
ON/STANDBY
2
Select the input source.
Main unit
INPUT
3
Play the selected source.
Main unit
Operation on each
source component
4
Adjust the volume.
Main unit
VOLUME CONTROL
DOWN UP
To To
decrease increase
volume volume
GRC
ON/STANDBY
GRC
Main Menu
ENTER
C D
Tape1 / MD
or
ENTER
GRC
or
TapeA
CD
ENTER
ENTER
ENTER
ENTER
GRC
To increase volume
VOLUME
To decrease volume
5
@
: Keys or controls to be used in this operation
÷ Load the CD player or cassette deck with the software to be played.
\Read the instruction manuals of the associated components.
With the main unit operation, the input sources are switched as shown below.
1 VCR
2 AUX
3 TAPE 1 / MD *1
4 TUNER (frequency display)
5 CD
6 DVD-D
7 DVD-A / 6ch INPUT *2
8 LD -D
9 LD -A
0 CABLE / SAT
*1: To change the TAPE 1 display to MD display
*2: To change the DVD-A display to the 6ch INPUT
display
To enable system-control operation, the displayed information should
be set according to the actually connected components.
÷ Note for using the 6ch INPUT
÷ Step 3 can be omitted if the easy operation feature is available.
One-touch operation
Pressing the play key of the CD player or cassette deck starts up the
system automatically and starts playback. When this operation is
used, steps 1 and 2 can be omitted.
V O L U M E - 5 )
÷ The time taken till the volume level is displayed is variable depending
on the current operating condition.
÷ Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change (AI VOLUME function).
÷ The sound of input source cannot be listened to while TAPE 2
(MONITOR) is ON.
C-V750 (En/T)
AV CONTROL CERTER KC-2
The selected source is displayed.
C D
0
(
Volume level is displayed.
dB
∞
(