Controls And Indicators - Kenwood C-V750 Instruction Manual

Controls and indicators

10
Opening/closing the door
OPEN/CLOSE
When opening or closing the door, be careful not to catch
Note Note
your finger in the door. Otherwise there is a risk of injury.
Changing the input selection display (AUTO key)
*1: To change the TAPE 1 display to MD display
1 Select "TAPE 1" with the INPUT SELECTOR .
2 Press and hold the AUTO key for more than 2 seconds, until
"MD" is displayed.
Each press switches the indication.
1 TAPE1
*2: To change the DVD display to the 6ch INPUT display
1 Select "DVD" with the INPUT SELECTOR .
2 Press and hold the AUTO key for more than 2 seconds, until "6
ch INPUT" is displayed.
Each press switches the indication.
1 DVD-A
Switching the display mode (DISPLAY key)
Use the following procedure to change the display mode.
1 Press the DISPLAY key (remote control only).
Each press switches the indication.
1 INPUT SELECTOR
display
2 MD
2 6ch INPUT
2 DOLBY/DSP/ 3 Time
STEREO
display
To make the system control operation, the input selection display
should be switched according to the actually connected compo-
nents.
About the system control connections
÷ The time display is displayed for only 5 seconds, after which the INPUT
SELECTOR display appears automatically.
display
÷ The display of 2 is not shown during SOURCE DIRECT and 6ch INPUT
operations.
C-V750 (En/T)
8