Setting up the GRC according to your AV CONTROL CENTER
Perform the following procedure after inserting batteries for
the first time and every time after changing them.
Preparation
÷ Press the
of the main unit to the ON mode.
Model Type Setup (GRC setup procedure)
1
Loading batteries
1 Remove the cover.
2
2
Check the display.
The "Model Type Setup" screen ap-
pears.
3
Move the cursor to the Model type icon matching the AV CONTROL CENTER.
1 Identify the model type.
(use the table on the right).
2 Move the cursor.
It can be moved in 8 directions depend-
ing on how you press the joystick key.
The icon on which the cursor is moved blinks in reverse
video.
4
Enter the selection.
Press the ENTER key.
(ON/STANDBY) key
2 Insert batteries.
3 Close the cover.
ENTER
ENTER
ENTER
Setup of the Graphical Remote Control (GRC) unit
Main operation menu
(The displayed icons are variable depending
on the model.)
Caution in battery replacement
÷ Insert four AAA-size (R03/UM-4) batteries
as indicated by the polarity marking.
÷ To maintain the memory of the settings you
made before, complete the battery replace-
ment operation within 30 seconds.
÷ The procedure on the left should also be per-
formed when resetting the GRC (as a measure
against its malfunction). However, in this case,
wait for about five minutes after removing the
batteries and before re-inserting them.
Model Type Setup
Model 1
Model 4
Model 2
Model 5
Model 3
Model 6
AV CONTROL CENTER
Model
C-V100 ............................................... Model 1
C-V150 ............................................... Model 1
C-V300 ............................................... Model 2
C-V350 ............................................... Model 2
C-V500 ............................................... Model 3
C-V550 ............................................... Model 4
C-V700 ............................................... Model 4
C-V750 ............................................... Model 4
C-V770 ............................................... Model 3
To change Model Type Setup
1 Select Set Up.
Set Up
2 Press the ENTER key.
ENTER
3 Select Reset.
Reset
4 Press the ENTER key.
ENTER
5 Perform the setup procedure from step "2 Check the display".
÷ The above operation clears all of the previously made settings and
resets the unit to the initial condition.
C-V750 (En/T)
(Model Type Setup)
ENTER
VOLUME
Model Type Setup
Model 1
Model 4
Model 2
Model 5
MUTE
Model 3
Model 6
ON/STANDBY
GRC
"Model Type Setup" icon
13