Table of Contents
Advertisement
INSTALLATION GUIDE
4.6
Installation of Web Guide/Connector Panel
1. Remove the filler plate (2 screws) from lower side cover beneath the suction brake. See figure
below.
2. Remove the lower right side cover from the printer.
Filler Plate
Lower Side Cover
3. Remove the four mounting screws securing the connector panel to the mounting bracket.
4. Feed the connector panel through the hole of the lower sides cover.
5. Mount the lower side cover.
6. Remove the contents of accessory Box 3 containing the Web Guide assembly.
7. Remove the filler plate from the Web Guide Box and discard, retain (4) 6mm screws.
8. Feed the Connector Panel Assembly through the Web Guide Box as shown in the figure above.
9. Attach the Connector Panel Assembly through the Web Guide Box and attach with the (4) M4 x
6mm long screws provided.
13
Web Guide Box
Assembled
Mounting Screws
Connector Panel
Advertisement
Table of Contents
