Table of Contents
Advertisement
6-6
PCI Slot Setup
An optional riser card (p/n RSC-RR1U-E8) may be installed into the PCI-E slot on
the motherboard to support one full height, half-length expansion card. The PCI slot
does not require a screw to hold the card in place.
Installing Expansion Cards
1. Disconnect the power supply, lay the chassis on a flat surface, and open the
chassis cover as described previously.
2. Slide the PCI slot clip upward.
3. Slide the PCI slot shield toward the side of the chassis and remove the
shield.
4. Secure the riser card to the motherboard.
5. Simultaneously slide the expansion card (with "L" bracket) into the PCI slot
and the riser card.
6. Replace the PCI slot clip to secure the expansion card.
Expansion Card
Slot Shield
Figure 6-8. Installing the Expansion Card
Chapter 6: Advanced Chassis Setup
PCI Slot Clip
6-7
Advertisement
Table of Contents
