Supero SUPERSERVER 5018A-MLTN4 User Manual page 78

S S
UPER ERVER 5018A-MLTN4 User's Manual
Replacing the Blower Fan
1. Power down the system and disconnect the power cord from the from the
rear of the power supply.
2. Place the chassis on a stable hard surface and remove the chassis cover as
described in the previous section.
3. Remove the two long screws at the front of the blower and the two long
screws at the back of the blower and set them aside for later use.
4. Lift the blower up and out of the chassis and disconnect the wiring.
5. Replace the blower with another blower of the same model and reconnect the
wiring.
6. Align the thru holes in the blower with the thru holes in the chassis.
7. Secure the blower to the chassis using the screws previously set aside.
8. Close the cover and reconnect the power cord to the power supply.
Long Screws
Figure 6-4. Installing the Blower Fan
6-4