Rear Panel - A-Neu Video HD-44 Instruction Manual

REAR PANEL

1 DC POWER INLET
The Switcher is fi tted with a DC power plug input connector.
Ensure that the used is of an approved type and is of suffi cient
current carrying connector capacity with the correct voltage and
connector polarity. 12Volt~ DC power supply 3A Max
(Center pin positive).
2 IR EXTENDER CONTROL
Support one of IR Extender
Extend distance maximum 300Meters / ~1000 feet
When you plug the External IR extender into the switcher,
the front panel IR receiver remains active.
3 RS-232 CONNECTION
RS-232 control port to allow for interfacing to a PC, Such as
a computer or touch panel control, to the switcher via this
DB-9pin Female connector for serial RS-232 control.
5 INPUTS- 1,2,3,4 HDMI
Connect a signal link of HDMI direct digital video/audio to this
Female HDMI connector. This connector supports HDMI digital
video/audio and DVI digital video sources.
HDMI Digital Video/Audio, Connector with fi x screw
Input 1 ~ Input 4
6 OUTPUTS- 1,2,3,4 HDMI
Connect a signal link of HDMI direct digital video/audio to this
Female HDMI connector. This connector supports HDMI digital
video/audio and DVI digital video sources.
HDMI Dig~1 Video/Audio, Connector with fi x screw
Output 1 ~ Output 4
REAR PANEL
6
Power Jack:
ᴓ
DC Jack - Inner OD 2.1mm (+ )
ᴓ
Outside OD 5.5mm (GND)
Power input - 12VDC, 3A
IR Extender Jack:
ᴓ
Female Jack - inner OD
Remote port :
DB-9pin Female connector
HDMI digital video/audio connector:
HDMI Female connector.
Note: With the proper adapters, the switcher
can be used with DVI digital video signals
HDCP compliant. DVI does not support audio.
HDMI digital video/audio connector:
HDMI Female connector.
Note: With the proper adapters, the switcher
can be used with DVI digital video signals
HDCP compliant. DVI does not support audio.
3.5 mm