Table of Contents
Advertisement
MORE STUFF
Note: Turning the unit System Power 011 via RS-232 will extinguish the LED channel display leaving only the Power
SW~ LED on. The Video and Audio outputs will also mute. While the unit is turned 011 by RS-232 it will continue to accept and
act upon switching commands. For example, if the unit is in the off mode (via RS-232) and you send a command to switch an
input to an output that route will complete and the video and audio will now appear on that channel only. The front panel LED
channel display for that particular output will also show the input selected (for that single output channel only). The remaining
LED's will remain off and video and audio outputs muted. The unit will still return status and change messages in response to
commands sent while in Power Off state. A hard reset command (SBALLRST) will return the unit to normal operation and also
unlock the front panel.
Power Off mode.
SBSYSMOF
SBSYSMON
Unit will respond with
SBALOFAK
SBALONAK
Example: Put Unit in Standby (Soft Power)
SBSYSMOF
SBALOFAK
FRONT PANEL LOCK
Note: Hard resetting the unit will unlock the Front Panel controls.
SBSYSMLK
SBSYSMUK
Unit will respond with
SBSYSLOK
SBSYSULK
Example: Lock Front Panel Buttons
SBSYSMLK
SBSYSLOK
UNIT RESET
SBALLRST
Unit will respond with
SBRSTACK
Example: Reset all outputs to Input 1
SBALLRST
SBRSTACK
RS-232 SERIAL COMMANDS
- Put system into Standby (Soft Power Off)
- Bring unit out of Standby (Soft Power On)
- Unit is in Standby
- Unit is no longer in Standby
-Send
-Rcvd
- When front panel is locked, changes can only be made by RS-232
- Front Panel Unlock
- Front Panel has been Locked
- Front Panel has been Unlocked
-Send
-Rcvd
- Reset every output to Input 1
- Unit has reset each Output to Input 1
-Send
-Rcvd
11
Advertisement
Table of Contents
