Chapter 4 User Preferences; Introduction - Motorola Symbol DS3407 Reference Manual

Chapter 4 User Preferences

Introduction

You can program the digital scanner to perform various functions, or activate different features. This chapter
describes each user preference feature and provides programming bar codes for selecting these features.
The digital scanner ships with the settings shown in
Parameters for all host device and miscellaneous defaults). If the default values suit requirements, programming is
not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when you power down the digital scanner.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
Select a host type (see each host chapter for specific host information) after the power-up beeps sound. This is
only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan
menus, asterisks (
*Restore Defaults on page
*
) indicate default values.
*
*
Indicates Default
Table 4-1 on page 4-3
4-4. Throughout the programming bar code
High Volume
Feature/Option
(00h)
Option Hex Value for programming
via SSI command
(also see Appendix A, Standard Default