Infinite FINA250 User Manual page 49

10.2.3 Working Process and Characteristics
1¡ ¢ Users can set the temperature of front heater by operating on LCD control panel. For there is only one
sensor to detect the temperature, so users can not set or change the pre-heating temperature by operating
on LCD control panel.
2¡ ¢ Heating power supply is independent from control power supply. Please turn on the heating power before
turning on the power for the printer. Once the power is on, the system heats up automatically to set
temperature and keeps the temperature at the set value. Without turning on power for printer, the heating
system will not work. However, there is still AC 220V inside machine.
3¡ ¢ Temperature detector lies about 50 cm to the right physical printing original position. Print media should
cover this region when printing.
4¡ ¢ After printing, make sure to turn off the two powers.
10.3 Far Infrared Heating System
The far infrared heating system has four far infrared tubes to heat. The left switch is used to
control the two left tubes; the left knob is used to adjust the power of the two left bubbles. The
right switch is used to control the two right tubes; the right knob is used to adjust the power of the
two right bubbles.
The position of switch and knob is as picture below:
1
FINA250 Ó Ã » § Ê Ö ² á
2
Far Infrared Heating Adjusting Knob
1-
Far Infrared Heating Switch
2-
Far Infrared Heating Power Socket
3-
Power Socket
4- Fan
Switch
5- Power
Far Infrared Heating Switch
Figure 10-2
- 45 -
3 4
5