Table of Contents
Advertisement
1.
After all parts are installed, put the printer at the proper place. Removing carefully all the packaging
materials like foam, adhesive tape.
2.
Connect power cables and data cables. Power protective switch can only control heating power and it is at
open status in normal condition (It's in the open status when far from red point).
3.
After everything is ready, switch on power.
4.
Load media.
5.
Test to check if print head is good to print. If the test result is unsatisfactory, you should clean print head.
FINA250 Ó Ã » § Ê Ö ² á
- 7 -
Advertisement
Table of Contents
