Watch Dog Timer Enable; Vga Enable - Supermicro SuperO A1SAM-2750F User Manual

A1SAM/A1SRM Series Motherboard User's Manual

Watch Dog Timer Enable

Watch Dog (JWD1) is a system monitor that
can be used to reboot the system when a soft-
ware application hangs. Close pins 1-2 to re-
set the system if an application hangs. Close
pins 2-3 to generate a non-maskable interrupt
signal for the application that hangs. See the
table on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.

VGA Enable

Jumper JPG1 allows the user to enable the
onboard VGA connector. The default setting
is pins 1-2 to enable the connection. See the
table on the right for jumper settings.
B
JBAT1
JF1
BATTERY
SP1
A
BUZZER
COM2
USB4/5
LAN2/LAN4 LAN1/LAN3
JUIDB1
JVGA1
BMC
JLAN2 JLAN1
LAN3/4 LED
PHY
A1SAM/A1SRM Series
Rev. 1.01
BIOS
SoC Processor
JBT1
1
2-28
Jumper Setting
Pins 1-2
Pins 2-3
Open
Jumper Setting
Pins 1-2
Pins 2-3
USB 2/3 USB0/1
COM1
IPMI_LAN
PWRI2C
Watch Dog
Jumper Settings
Definition
Reset (default)
NMI
Disabled
VGA Enable
Jumper Settings
Definition
Enabled (Default)
Disabled
A. Watch Dog Enable
B. VGA Enable