Populating Memory Modules; Dimm Installation - Supermicro SuperO A1SAM-2750F User Manual

A1SAM/A1SRM Series Motherboard User's Manual

Populating Memory Modules

1. Install the desired number of DIMMs into the memory slots, starting with DIM-
MA1, then DIMMB1, then DIMMA2, then DIMMB2. Pay attention to the notch
along the bottom of the module to prevent incorrect DIMM module installation.
2. Insert each DIMM module vertically and snap it into place. Repeat step 1 until
you complete the memory installation. See the section below for more details
on DIMM memory installation.

DIMM Installation

1. Insert the desired number of DIMMs into the memory slots, starting with
DIMMA1 (Channel A, Slot 1.) For the system to work properly, please use the
memory modules of the same type and speed in the same motherboard.
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the lock positions to secure the DIMM module into
the slot.
Module Notch
Module Key
Socket Key
2-6
Side Clips