Flymo Contour Original Instructions Manual page 3

3. Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is damaged.
Do not touch the electric cable until the electrical sup-
ply has been disconnected. Do not repair a cut or
damaged cable. Replace it with a new one.
4. Your extension cable must be uncoiled, coiled cables
can overheat and reduce the efficiency of your trimmer.
5. Keep the cable clear of the cutting area and obstacles
at all times.
6. Do not pull cable around sharp objects.
7. Always switch off at the mains before disconnecting
any plug, cable connector or extension cable.
8. Never pull on the cable to disconnect any of the plugs.
9. Switch off, remove plug from mains and examine electric
supply cable for damage or ageing before winding
cable for storage. Do not repair a damaged cable, replace
it with a new one. Use only Flymo replacement cable.
10.Always wind cable carefully, avoiding kinking.
11.Never carry the product by the cable.
12.Use only on AC mains supply voltage shown on the
product rating label.
13.Our products are double insulated to EN60335.
Under no circumstance should an earth be connected
to any part of the trimmer.
Preparation
1. While using your product always wear eye protection
substantial footwear and long trousers. Do not operate
the equipment when barefoot or wearing open sandals.
2. Before using the machine and after any impact, check
for signs of wear or damage and repair as necessary.
3. Inspect the area to be cut before each use. Remove
all objects such as stones, broken glass, nails, wire,
string etc, which can be thrown or become entangled
in the trimmer head.
4. Before use, inspect the area for wildlife, especially
hedgehogs.
5 . Check that the cutting head is fitted correctly.
Use
1. Use the trimmer only in daylight or good artificial light.
2. Avoid operating your trimmer in wet grass, where feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and wear
non-slip footwear.
5. Do not walk backwards when trimming, you could trip.
IMPORTANT
If you want to use an extension cable when operating your
product, only the following cable dimensions should be used:
- 1.0 mm 2 : max length 40m
2
- 1.5 mm : max length 60m
2
- 2.5 mm : max length 100m
Minimum rating:
1.00mm 2 size cable, 10 amps 250 volts AC.
THE CONTOUR POWER PLUS IS SUPPLIED WITH AN
ELECTRIC MAINS CABLE WIRED DIRECTLY INTO THE
PRODUCT.
1.If the supply cord is damaged, it must be replaced by your
local Husqvarna UK Ltd. Approved Service Centre or simi-
larly qualified persons in order to avoid a hazard.
2.Flymo Extension Cables are available from your
local Husqvarna UK Ltd. Approved Service Centre.
3.Do not wire an extension cable directly to your product
yourself. Please contact your local Husqvarna UK Ltd. Ap-
proved Service Centre for further information on the con-
nectors and kits available.
4.Only use extension cables specifically designed for out-
door use and which conform to one of the following specifi-
cations: Ordinary rubber (60245 IEC 53), Ordinary PVC
(60227 IEC 53) or Ordinary PCP (60245 IEC 57)
CONNECTORS
Flymo connectors are suitable for use with 2 core cable only.
Under no circumstances should these connectors be used
for earthed products.
All Flymo connectors and cables are of splashproof con-
struction. They are not waterproof and must not be left out-
side permanently nor should they be submerged or
immersed in water. Do not let cable lay or trail through pools of
Walk never run.
6. Keep cutting head below waist level.
7. Switch off before pushing the trimmer over surfaces
other than grass.
8. Never operate the trimmer with damaged guards or
without guards in place.
9. Never fit metal cutting elements.
10.Keep hands and feet away from the cutting means at
all times and especially when switching on the motor.
11.Never pick up or carry a trimmer by the cable.
12.Do not lean over the trimmer guard - objects may be
thrown by the cutting line.
13.Beware of cut-off pieces of nylon line ejected during
use.
14.Remove the plug from the mains :
- before leaving the trimmer unattended for any period;
- before clearing a blockage;
- before checking, cleaning or working on the appliance;
- if you hit an object. Do not use your trimmer until you are
sure that the entire trimmer is in a safe operating condition;
- if the trimmer starts to vibrate abnormally. Check im-
mediately. Excessive vibration can cause injury.
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be sure the
trimmer is in safe working condition.
2. Replace worn or damaged parts for safety.
3. Only use the replacement cutting line specified for
this product.
4. Only use replacement parts and accessories recom-
mended by Husqvarna UK Ltd.
5. After any maintenance in dealing with the cutting line,
always return the product toits normal operating posi-
tion before switching on.
6. To avoid the risk of injury keep fingers and hands clear
of the line cutter on the leading edge of the guard.
7. Clean unit with a dry cloth. Never use metal objects to
clean the unit.
8. Inspect and maintain the trimmer regularly. Any re-
pairs must be carried out by an authorised repairer.
9. Store in a cool dry place and out of reach of children.
Do not store outdoors.
10.Allow the product to cool for atleast 30 minutes before
storing.
Cables
water or splashed with water from hose pipes.
MAINS PLUG REPLACEMENT
• If the plug supplied is cut off it should be destroyed.
There is an electric shock hazard if a cut off plug is in-
serted into a 13 amp socket.1.
Flymo products are double insulated to EN60335 and
under no circumstances should an earth be connected
to any part of the product.
2. Ensure the mains voltage suits your product.
3. IMPORTANT!
The wires in the mains lead are coloured in accordance with
the following code:
BLUE -
BROWN -
The wire which is coloured BLUE must be connected to the
Terminal which is marked with the letter 'N' or coloured BLACK.
The wire which is coloured BROWN must be connected to the
Terminal which is marked with the letter 'L' or coloured RED.
4. It is important that the outer sheath is clamped correctly
into the 3-pin plug.
5. If in doubt consult your local Service Repairer or quali-
fied electrician before the machine is used.
6. A 13 Amp fuse must be fitted to the Mains Plug.
7. The normal plug fuse and household fuse only protect
the electrical equipment and are not a safeguard against
electrocution.
If your product is hard wired i.e. non-detachable mains
electric cable, a conversion kit and extension cable is
available from all Approved Service Centres which
can be found in your local Yellow Pages.
No earth required.
NEUTRAL
LIVE