Flymo Contour Original Instructions Manual
Hide thumbs
Also See for Contour:
- Manual (80 pages) ,
- Original instructions manual (10 pages) ,
- Operating instructions manual (9 pages)
Subscribe to Our Youtube Channel
Related Manuals for Flymo Contour
Summary of Contents for Flymo Contour
- Page 1 Contour Original Instructions For all customer enquiries or for replacement parts, contact:- ¤ 01325 300303 www.flymo.com customer.services@husqvarna.co.uk...
-
Page 2: Carton Contents
Instruction Manual Guard Wheel IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product. IF ANY PARTS ARE MISSING CONTACT:- Husqvarna UK Ltd. Customer Service Department direct Telephone : 01325 300303 FAX : 01325 302530... - Page 3 Do not repair a damaged 13. Remove the plug from the mains : cable, replace it with a new one. Use only Flymo re- before leaving the trimmer unattended for any period; placement cable.
-
Page 4: Assembly Instructions
Assembly Instructions Shaft Assembly (A) 1. Locate the lower shaft (A1) into the upper shaft (A2). 2. Grasp firmly and hold steady the lower shaft. Locate the upper shaft and snap together firmly. • The unit is correctly assembled when the gap be- tween the upper and lower shaft has been closed. -
Page 5: How To Trim And Edge
How to trim and edge • WARNING • The use of eye protection is recommended. Do not lean over the trimmer whilst trimming or edging, objects may be thrown by the cutting line. Do not allow cutting head to rest on the ground. Do not overload your trimmer. -
Page 6: Cutting Head
Keep fingers and hands clear of the line cutter on leading edge of guard. Caring for your Contour After you have finished using your Flymo Contour follow the procedure below: 1. Disconnect from the mains electricity supply. -
Page 7: Fault Finding Chart
Maintenance 4. Remove the wheel by pressing one of the buttons. Clean the wheel and groove on trimmer head with a soft brush (V & W). 5. Attach wheel as described in Wheel Assembly. 6. Inspect the trimmer carefully, especially the parts of the cutting head. -
Page 8: Service Recommendations
Service Recommendations • Your product is uniquely identified by a silver and black product rating label. • We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture Failures not covered by guarantee within the guarantee period, Husqvarna UK Ltd., through its Au-...
Need help?
Do you have a question about the Contour and is the answer not in the manual?
Questions and answers