Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
Beta, ED Beta VCRs
8 mm VCR
If you have video equipment other than Sony brand that you want to control
with the projection TV's remote control, use the following procedures to
program the remote control.
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
From the "Manufacturer's Codes" listed on page 70, select the three-digit
code number for the manufacturer's code for your component. If more than
one code number is listed, start with the number listed first. Use the code
number to complete the following procedure.
To program a cable box or a satellite receiver
1 1 1 1
Open the panel of the remote control.
2 2 2 2
inside the panel.
3 3 3 3
Close the panel and press
4 4 4 4
Enter the three-digit manufacturer's code number using the
5 5 5 5
6 6 6 6
To check if the code number works, aim the projection TV's remote
control at the component and press the green
corresponds with that component. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
on Remote Control