Other Information; Programming The Remote Control - Sony KF-60DX100 Service Manual

Other Information

Programming the Remote Control

The remote control is preset to operate Sony brand video equipment.
Sony
Equipment
Beta, ED Beta VCRs
8 mm VCR
VHS VCR
DVD Player
If you have video equipment other than Sony brand that you want to control
with the LCD projection TV's remote control, use the following procedures
to program the remote control.
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
From the "Manufacturer's Codes" listed on page 79, select the three-digit
code number for the manufacturer's code for your component. If more than
one code number is listed, start with the number listed first. Use the code
number to complete the following procedure.
To program a cable box or a satellite receiver
1 1 1 1
Open the panel of the remote control.
2 2 2 2
Press inside the panel.
CODE SET
3 3 3 3
Close the panel and press
4 4 4 4
Enter the three-digit manufacturer's code number using the
5 5 5 5
Press ENTER .
6 6 6 6
To check if the code number works, aim the LCD projection TV's
remote control at the component and press the green
that corresponds with that component. If it responds, the programming
is completed. If not, try using the other codes listed for that
manufacturer.
Switch Position
on Remote Control
AV1
AV2
AV3
DVD
SAT/CABLE (FUNCTON)
Programmable
Code Number
303
302
301
751
.
0-9 buttons.
button
POWER
(Continued)
77