Program Recording (Cd = Tape) - Kenwood HM-331 Instruction Manual

Program recording (CD = TAPE)

Desired CD tracks can be programmed in the desired sequence and recorded onto a tape.
Recording preparation is required.
(Be sure to put the cassette deck in stop mode.)
1
Program the desired sequence of CD tracks.
CD = TAPE
Perform steps 1 and 2 of the procedure in
"Listening in the desired sequence (Program
playback)".
2
Start recording.
÷ Recording of the programmed tracks in the programmed order starts.
÷ To perform operation on the main unit, see step 3 in the procedure in "One-touch recording".
To interrupt a recording
(Recording and playback will be
stopped.)
™\
¢
TAPE
O.T.E.
7
Convenient Recording Methods
÷ When the PGM key is pressed to cancel the edited
contents, the entire editing contents will be erased.
÷ Tracks programmed in excess of the tape recording time
will be cut off.
At the end of the recording
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
35
HM-331 (En/T)
›