Omron E5EC-T Datasheet page 17

E5 C-T
This diagram shows all of the setting levels. To move to the advanced function setting level and calibration level, you must enter passwords. Some
parameters are not displayed depending on the protect level setting and the conditions of use.
Manual Control
Level
Used to set the MV
manually.
*1 Set the PF Setting parameter to a-m (Auto/Manual).
*2 The No. 1 display will flash when the keys are pressed for 1 s or longer.
*3 Set the PF Setting parameter to pfdp (monitor/setting items).
Starting in manual mode
Power ON
Level changes
automatically.
Press O or
*1
S Key for at least 1 s.
Operation Level
Press O Key for at
least 3 s while a-m is Used for SPs and other
*2
displayed.
basic settings and
monitoring.
Press S Key
*1
for at least 1 s.
Press O
Key for at
least 1 s.
Parameters for all PID
sets (e.g., PID
constants)
Initial Setting Level
Used to set the input type
and other basic settings.
Release protection and then
enter the password (−169) for
the amoV (Move to Advanced
Function Setting Level)
parameter.
Advanced Function
Setting Level
Advanced settings
Enter the password (1201)
while cmov (Move to
Calibration Level
parameter) is displayed.
Calibration Level
Press O and M Keys
for at least 1 s.
Press S Key.
Press O Key
for less than 1 s.
Press O Key
for less than 1 s.
Press O Key
PID Setting
for less than 1 s.
Level
Press O Key for
*2
at least 3 s.
Control stops.
Press O Key for less
than 1 s (only models
with communications).
Press O Key for at
least 1 s.
E5EC-T/E5AC-T
Protect Level
Used to set protection
for operations.
Press O and M Keys
*2
for at least 3 s.
*3
Program Setting
Level
Parameter and
segment settings for
all programs
Press O Key
for less than 1 s.
Adjustment Level
Adjustment parameters
(e.g., PID constants for
current PID set)
*3
Press S Key.
Monitor/Setting
Item Level
Used to display
specified monitor and
setting items.
Communications
Setting Level
Communications settings
17