Instruction
To set the clock
1. Press "CLOCK button".
2. Press "TIMER setting button" to set the
3. Press "CLOCK button".
Turn the breaker ON
•
NOTE
•
54
is displayed.
blinks.
clock to the present time.
Holding down "
" or "
increases or decreases the time display.
blinks.
Turning ON the breaker opens the flap,
then closes it again. (This is a normal
procedure.)
Tips for saving energy
•
Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helps
save energy.
•
Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the cooling
(heating) effect.
•
Clogged air filters cause inefficient operation and waste
energy. Clean them once in about every two weeks.
Please note
•
The air conditioner always consumes 15-35 watts of electricity even while it is not
operating.
•
If you are not going to use the air conditioner for a long period, for example in spring or
autumn, turn the breaker OFF.
•
Use the air conditioner in the following conditions.
Mode
Operating conditions
COOL
Outdoor temperature: 2MK(X)S 10 to 46 °C
Indoor temperature: 18 to 32 °C
Indoor humidity: 80% max.
HEAT
Outdoor temperature: 2MXS –10 to 21 °C
Indoor temperature: 10 to 30 °C
DRY
Outdoor temperature: 2MK(X)S 10 to 46 °C
Indoor temperature: 18 to 32 °C
Indoor humidity: 80% max.
Operation outside this humidity or temperature range may cause a safety device to disable
the system.
" button rapidly
If operation is continued out of this range
• A safety device may work to stop the
3/4MK(X)S –10 to 46 °C
operation.
RK(X)S –10 to 46 °C
• (In multi system, it may work to stop the
operation of the outdoor unit only.)
• Condensation may occur on the indoor unit
and drip.
• A safety device may work to stop the
3/4MXS –15 to 21 °C
operation.
RXS –15 to 21 °C
• A safety device may work to stop the
3/4MK(X)S –10 to 46 °C
operation.
RK(X)S –10 to 46 °C
• Condensation may occur on the indoor unit
and drip.
C
HOME LEAVE
ON/OFF
TEMP
POWERFUL
MODE
FAN
SILENT
SENSOR
SWING
ON
CANCEL
OFF
TIMER
Recommended
temperature setting
For cooling:26°C – 28°C
For heating:20°C – 24°C
System Configuration
SiBE05-311
2
1.3