Error List - JUKI LK-1900B series Instruction Manual

Hide thumbs Also See for LK-1900B series:
Table of Contents

Advertisement

9-5. Error list

Error code Indication
Machine lock error
E007
The main shaft of the sewing machine
does not rotate due to some troubles.
E010
Pattern No. error
Back-uped pattern No. has not been
registered in the data ROM, or it is set to
readout inoperative.
Pattern No. is set to "0".
E011
External media not inserted
USB thumb drive is not inserted.
Read error
E012
Data cannot be read from the USB thumb
drive.
E013
Write error
Data cannot be written on the USB thumb
drive.
E014
Write-protect
USB thumb drive is write-protected.
E015
Format error
USB thumb drive cannot be formatted.
E016
External media capacity over
Memory capacity of the USB thumb drive
to write pattern data is not sufficient.
E017
Machine memory capacity over
Memory capacity of the sewing machine
to write pattern data is not sufficient.
File size over
E019
The pattern data to be read from the USB
thumb drive is too large. (Max.: Approxi-
mately 20000 stitches)
E024
Pattern data size over
The pattern data to be written on the sew-
ing machine memory is too large. (Max.:
Approximately 20000 stitches)
E030
Needle bar position error
Needle bar is not in the specified position.
E040
Sewing area over
The sewing area is beyond the limit.
Description of error
62
Corrective measure
Turn OFF the power switch
and remove the cause of
troubles.
P r e s s t h e r e s e t k e y a n d
check the pattern No.
Check the contents of mem-
ory switch No. 201.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Re-operation is enabled after
resetting.
Turn the hand pulley to re-
turn the needle bar to its
specified position.
P r e s s t h e r e s e t k e y a n d
check the pattern and X/Y
scale rate.
Remarks
This error is
output when
max. sewing
a r e a , 3 0 x
4 0 i s o v e r.
Interference
o f t h e w o r k
c l a m p f o o t
with needle is
not protected.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents