Controlling Tone-Based Services; Setting Up The Hands-Free Phone - Kenwood DDX6034M Instruction Manual

Hands Free Unit Control

Controlling Tone-based Services

Uses tone base service using DTMF (Dual Tone
Multi Frequency).
1 Display the Talking screen
See <Calling by Entering a Phone Number>
(page 46).
2 Display the DTMF input screen
3 You can send tones during a call
48 DNX7340BT/DNX7340BTM/DDX7034BT/DDX7034BTM/DDX6034/DDX6034M

Setting Up the Hands-Free Phone

The Hands-Free system can be set as follows.
1 Display the Hands-Free Control screen
See <Making a call> (page 45).
2 Display the Hands Free Setup screen
3 Set each item
[Auto Response] Sets an automatic response
time after call termination. (
"OFF": This function can not use.
"0-99": Sets to calling ring time (second).
[Phone Voice] Sets a ringing tone output
position. ( "Front All")
"Front L": Outputs the tone from the front left-
hand side speaker.
"Front R": Outputs the tone from the front
right-hand side speaker.
"Front All": Outputs the tone from the both
front speakers.
"OFF")