Controlling Tone-Based Services; Setting Up The Hands-Free Phone - Kenwood DDX8024BT Instruction Manual

Hands Free Unit Control

Controlling Tone-based Services

Uses tone base service using DTMF (Dual Tone
Multi Frequency).
1 Display the Talking screen
See <Calling by Entering a Phone Number>
(page 46).
2 Display the DTMF input screen
3 You can send tones during a call
48 DNX9240BT/DDX8024BT/DDX8054BT

Setting Up the Hands-Free Phone

The Hands-Free system can be set as follows.
1 Display the Hands-Free Control screen
See <Making a call> (page 45).
2 Display the Hands Free Setup screen
3 Set each item
[Auto Response] Sets an automatic response
time to pick-up an incoming call. (
"OFF": This function is disabled.
"0-99": Sets the incoming call ringing duration
(in seconds).
[Phone Voice] Sets the phone call voice /
ringing tone output position. (
"Front L": Outputs the phone call voice from
the front left-hand side speaker.
"Front R": Outputs the phone call voice from
the front right-hand side speaker.
"Front All": Outputs the phone call voice from
both front speakers.
"OFF")
"Front All")