Adjusting The Input Level - Kenwood Sovereign VR-5080 User Manual

How Do I Adjust the Sound?
2. Press the MULTI CONTROL (%/fi) button to select the desired vol-
ume level, then press the SOUND button repeatedly until "SOUND
FIXED" is displayed.
If you select another source device or turn off the receiver, the above set-
ting is reset to the level adjusted in Chapter Two of the Connection and
Setup Guide.

Adjusting the Input Level

If the front panel CLIP indicator will flash red continually, lower the analog
input level for the source device you're listening to. (Setting the proper in-
put level eliminates distortion that occurs if a source device's output level
is too high. Occasional brief flashing of the CLIP indicator is okay).
1. Select the input to be adjusted (see "Selecting the Inputs" on page
35).
2. Press the SOUND button on the Remote Control unit until Analog
Level is displayed.
3. Press the LCD cursor up/down (
unit to select the desired input level, then press the Home button.
Select one of the three input levels; 0 dB, -3 dB and -6 dB. (The dB is
the unit expressing the amplitude of sound.)
Operation on the receiver:
1. Press the SOUND button inside the door repeatedly until ANLG IN-
PUT is displayed.
2. Press the MULTI CONTROL (%/fi) button to select the desired input
level, then press the SOUND button repeatedly until "SOUND FIXED"
is displayed.
/ ) button on Remote Control
15