Input Level Adjustment (Analog Sources Only); Adjusting The Sound - Kenwood VR-9070 Instruction Manual

Normal playback

Input level adjustment (analog sources only)

SOUND
Input Selector
keys
MULTI %/ fi,
@/#
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the CLIP indicator
will light up to indicate the source signal. Adjust the input level.
SP
A B
L C R
LFE
SL S SB SR
1 Use the INPUT SELECTOR key or Input Selector keys to select the
source of which the input level you want to adjust.
• You can store a separate input level for each input source.
2 For the remote control unit, press the RCV MODE key to switch
to receiver mode.
3 Press the SOUND and 5/∞ keys or MULTI @/# keys repeatedly
until the "INPUT" indication appears.
4 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the
input level.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
• The adjustment mode is displayed for approximately 20 seconds.
• The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
5 Press the SOUND key again to return to the input indication.
24 EN
MULTI CONTROL
INPUT SELECTOR
SOUND
MUTE
CLIP CLIP CLIP
DOLBY PL II x
DOLBY PL II x

Adjusting the sound

ACTIVE EQ
TONE
PHONES BASS BOOST
ACTIVE EQ
TONE
BASS BOOST
MULTI %/ fi
Adjusting the TONE
You can adjust the sound quality when the receiver is in the PCM stereo
mode, analog stereo mode and when "THX OFF".
1 For the remote control, press the RCV MODE key to switch to
receiver mode.
2 Press the TONE key to select the TONE mode.
3 Use the MULTI CONTROL knob or MULTI %/fi keys to select
TONE ON/OFF.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
4 When in TONE ON selection, press the TONE key for the following
displays.
BASS : Select this to adjust the low frequency range.
TREBLE : Select this to adjust the high frequency range.
5 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the
sound quality.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
• The adjustment item is displayed for approximately 20 seconds.
• This function is available only for speakers connected to FRONT A
terminals.
MULTI CONTROL
VOLUME
CONTROL
RCV MODE
MUTE
LOUDNESS
VOLUME%/fi
STEREO
STEREO