Input Level Adjustment (Analog Sources Only); Adjusting The Sound - Kenwood KRF-V7090D Instruction Manual

Normal playback

Input level adjustment (analog sources only)

Input
SOUND
Selector
keys
Input Selector
keys
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the CLIP indicator
will blink to indicate the source signal. Adjust the input level.
SP
A B
L C R
LFE
SL S SB SR
1 Use the Input Selector keys to select the source of which the
input level you want to adjust.
• You can store a separate input level for each input source.
2 Press the SOUND and
∧ ∨
/
until the "INPUT" indication appears.
3 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the
input level.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
• The adjustment mode is displayed for approximately 20 seconds.
• The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
4 Press the SOUND key again to return to the input indication.
MULTI CONTROL
SOUND
MULTI %/ fi,
@/#
MUTE
CLIP CLIP CLIP
DOLBY PL II x
keys or MULTI @/# keys repeatedly
DOLBY PL II x

Adjusting the sound

BASS BOOST LOUDNESS
TONE
PHONES ACTIVE EQ
BASS BOOST
Adjusting the TONE
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 Press the TONE key to select the TONE mode.
2 Use the MULTI CONTROL knob or MULTI %/fi keys to select
TONE ON/OFF.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
3 When in TONE ON selection, press the TONE key for the follow-
ing displays.
BASS : Select this to adjust the low frequency range.
TREBLE : Select this to adjust the high frequency range.
4 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the
sound quality.
SP MUTE
A B CLIP
L C R
LFE
SL S SB SR
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
• The adjustment item is displayed for approximately 20 seconds.
• This function is available only for speakers connected to FRONT A
terminals.
Adjusting the LOUDNESS mode
You can adjust the Loudness function which controls the low volume
settings to maintain the music's richness. The adjustment can be made
when the receiver is in the PCM stereo and analog stereo mode.
Press the LOUDNESS key to turn the LOUDNESS setting ON.
• This function is available only for speakers connected to FRONT A
terminals.
To cancel
Press the LOUDNESS key again so that the "LOUDNESS"
indicator goes off.
MULTI CONTROL
VOLUME
MUTE
CONTROL
TONE
MULTI %/ fi
VOLUME %/fi
MUTE
ACTIVE EQ
LOUDNESS
STEREO
STEREO
21
EN