How Do I Operate Devices; Playback Of The Device Connected To The Cd2/Tape2 Monitor - Kenwood Sovereign VR-5080 User Manual

How Do I Operate Devices?

How Do I Operate Devices?
Your Remote Control unit makes it easy for you to control the different
devices connected to your receiver.
Once AV devices are connected and identified by Remote Control unit , it
can use the same remote control functions as the remotes originally pro-
vided with the AV devices. (See "Chapter Two: Setting Up Remote Con-
trol Unit" of the Connection and Setup Guide.)
For the operations of each device, please also refer to the manuals pro-
vided with them.

Playback of the device connected to the CD2/TAPE2 MONITOR

These instructions are for operating a second CD player or tape deck from
a single-Zone installation or from Zone A. For more information on op-
erating devices in a multi-Zone setup, see "Chapter Two: Using Remote
Control Unit in Multiple Zones" on page 54 of this manual.
1. Press the CD2/TAPE2 MONITOR button on the receiver's front panel.
The CD2/TAPE2 MONITOR indicator lights up.
2. Play the CD player or cassette deck in the same way as usual. As this
cannot be controlled from Remote Control unit, use the CD player or
cassette deck controls.
After completion of playback, press the CD2/TAPE2 MONITOR button
again so that the CD2/TAPE2 MONITOR indicator goes out.
For detailed operating procedures of your AV device, refer to its instruc-
tion manual.
Do not connect the system control cable from the second CD player or
second cassette deck, even if it supports system control.
36