Using Remote Control Unit in Multiple Zones
Operation using the SYS.POWER button on Remote Control unit
To perform the Multi-Zone operation, switch the Multi Zone function
On in advance (see page 55).
1. When the receiver is OFF (STANDBY mode):
•
To output the video and audio to Zone A, set the Zone setting of
the remote to Zone A then press the SYS.POWER button on the
remote.
•
To output the video and audio to Zone B, set the Zone setting of
the remote to Zone B then press the SYS.POWER button on the
remote.
2. When the video and audio are output to Zone A only:
•
To turn the receiver OFF (STANDBY mode), set the Zone setting
of the remote to Zone A then press the SYS.POWER button on the
remote.
•
To output the video and audio to Zone B, set the Zone setting of
the remote to Zone B then press the SYS.POWER button on the
remote.
3. When the video and audio are output to Zone B only:
•
To turn the receiver OFF (STANDBY mode), set the Zone setting
of the remote to Zone B then press the SYS.POWER button on the
remote.
•
To output the video and audio to Zone A, set the Zone setting of
the remote to Zone A then press the SYS.POWER button on the
remote.
4. When the video and audio are output to both Zone A and Zone B:
•
To turn the receiver OFF (STANDBY mode), set the Zone setting
of the remote to Zone A then press the SYS.POWER button on the
remote.
•
To defeat the video and audio outputs to Zone B, set the Zone
setting of the remote to Zone B then press the SYS.POWER button
on the remote.
The receiver can also be turned OFF (STANDBY mode) by pressing the
POWER button on the receiver.
56