Air-conditioning unit Saphir comfort IR (Australia) Installation example 1 Air-conditioning unit Saphir comfort IR 2a Supply air intake 2b Supply air outlet 3a Circulatory air return 3b Cold air outlet 4 Infra-red remote control 5 Infra-red receiver Table of contents Symbols used ................
Symbols used Notes for the use of air-conditioners Installation and repair of the device may only be carried – The Saphir comfort IR air conditioning unit is designed for out by properly qualified professionals. minimal power consumption. Nevertheless, you should check before taking the system into operation whether the camping site has adequate fuses (min.
Operating instructions Always observe the opera ting instructions and “Safety instructions” prior to starting! The vehicle owner is re- sponsible for the correct operation of the appliance! Remote control The symbols shown on the display become visible depending on the setting. Setup Resend / data transmission...
IR receiver and manual on / off In automatic mode the fan level is selected automatically depending on the room temperature. There is an additional pushbutton on the receiver (m), with which the unit can also be switched on and off without the In recirculated air mode, the interior air is circulated and remote control (e.g.
Maintenance Troubleshooting Located on the front side of the unit is a fluff filter (n) and a Is the motor home / caravan 230 V power supply lead particle filter (p) for cleaning the air in the room. connected, and are the fuses and circuit breakers OK? Fault Cause / Action Unit not cooling...
Accessories Technical data Determined on the basis of EN 14511 and the Truma test Noise suppressor for installation in the cold air pipe for addi- conditions. tional noise reduction within the living compartment (part no. 40040-60100). Manufacturer Truma Gerätetechnik GmbH & Co. KG P.O.
Warranty conditions air suc- – The company will only provide service on presentation tion intake of proof of purchase, on either the Truma product, or the from inside Supply air Caravan / RV / Pleasure Craft in which the Truma product...
Installation instructions 940 mm 30 mm 20 mm 290 mm 440 mm 200 mm 20 mm Fig. A Minimum installation dimensions for standard Fig. B Side view with the electrical connections installation Fig. C Standard installation of the air-conditioning unit...
– modifications to the unit (including accessories), Then seal the edges of the openings in the floor of the vehicle – failure to use original Truma parts as replacement parts and with underfloor protection. accessories, –...
Slide the cold air ducts (10) into the cold air emitters of the position. Mark mounting holes for the 4 side fastening brack- unit and route to the air outlet nozzles. Truma can supply a ets (3) and the 2 front and rear retaining brackets (2 – leg muffler for installing in the cold air system (part no.
EN61000-4-2:1995+A1:1998+A2:2001; EN61000-4-4:1995+A1:2001+A2:2001; EN61000-4- Truma offers side parts (18) in eight different colors for 5:1995+A1:2001 ; EN61000-4-6: 1996+A1:2001 ; EN61000- finishing the cover frames (17) in a visually pleasing way. 4-11:1994+A1:2001 ; EN378:2003; EN814:1997; EN60335-1, Please ask your dealer.
Page 16
In Australia, always notify the Dometic Service Centre if problems are encountered; in other countries the relevant service partners should be contacted (see Service Booklet or www.truma.com). Having the equipment model and the serial number ready (see type plate) will speed up processing.
Need help?
Do you have a question about the Saphir comfort IR and is the answer not in the manual?
Questions and answers