Table of Contents
Advertisement
3. Locate the hard disk drive that you want to remove.
Attention:
Never hot-swap a hard disk drive when its green activity LED is
flashing. Hot-swap a drive only when its amber status LED is lit (not flashing) or
when the drive is inactive (activity LED is off).
4. Removing a 2.5-inch hot-swap drive:
a. Slide the release latch (orange) up gently to unlock the drive handle.
b. Grasp the handle and pull the drive partially out of the bay and wait at least
20 seconds before you remove the drive from the EXP2500. This enables
the drive to spin down and avoids possible damage to the drive.
c. Make sure that there is proper identification (such as a label) on the hard
disk drive; then, gently slide it completely out of the EXP2500. If the drive
has failed, indicate that on the label.
d. Skip to step 6.
Chapter 4. Parts listing, EXP2512 and EXP2524 expansion enclosures
Drive-tray
assembly
Drive handle
Filler
panel
31
Hide quick links:
Advertisement
Table of Contents
