Table of Contents
Advertisement
4. Installing a 2.5-inch hot-swap drive:
a. Touch the static-protective package that contains the hard disk drive to any
unpainted surface on the outside of the enclosure; then, remove the hard
disk drive from the package.
b. Make sure that the drive-tray handle is in the open (unlocked) position.
c. Align the drive assembly with the guide rails in the bay.
d. Gently push the drive-tray assembly into the bay until the drive stops.
e. Rotate the drive-tray handle to the closed (locked) position.
Drive-tray
assembly
Drive handle
Filler
panel
Chapter 2. Installation
11
Hide quick links:
Advertisement
Table of Contents
