Table of Contents
Advertisement
DSP Setup
Car Type Fine Adjustments
Adjusting fine tuning of the speaker position
compensation value specified at <Car Type
Selection> (page 37).
Display
Item
"Front"
Front speaker
"Rear"
Rear speaker
"SW"
Subwoofer
1
Select the source
Press the [SRC] button. Turn the [VOL] knob and
press it when the desired item is displayed.
Select a source other than "STANDBY".
✍ SRC Select mode 2: Pressing the [SRC] button
repeatedly switches source.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Enter Car Type Adjustment mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select "Detailed Setup"
4
Select the item you want to set
Operation type
Selects the item.
Adjust each item.
Set the value
The settings of the delay time are automatically
identified and compensated by specifying the
distances of each speaker from the center of the
vehicle interior.
1 Set the front and rear positions and the height
of the reference point to the position of the ears
of the person sitting in the front seat, and set
the right and left positions to the center of the
vehicle interior.
2 Measure the distances from the reference point
to the speakers.
3 Calculate the distance difference in accordance
with the farthest speaker.
38
|
KDC-X8016BT/ KDC-X8016BTL/ KDC-X7016/ KDC-X7016L
Range
0 – 440 cm
0 – 440 cm
0 – 440 cm
(
: Factory setting)
>
"Car Type Adjust".
Operation
Turn the [VOL] knob.
Press the [4] or [¢] button.
Press the [VOL] button.
Reference point
FRONT
REAR
5
Exit Audio Control mode
Press the [MENU] button for at least 1 second,
and then press it again briefly.
X'Over Setting
Fine adjusting the following setting values
corresponding to the X'Over values set in the
section <Speaker Setting> (page 37).
Display
Item
"X'Over"
"Front"
"FC"
"SLOPE"
"Rear"
"FC"
"SLOPE"
"SubWoofer" "FC"
"SLOPE"
"PHASE"
1
Select the source
Press the [SRC] button. Turn the [VOL] knob and
press it when the desired item is displayed.
Select a source other than "STANDBY".
✍ SRC Select mode 2: Pressing the [SRC] button
repeatedly switches source.
FRONT
REAR
SUB-W
Range
Front High Pass Filter
Through, 30, 40, 50, 60, 70, 80, 90,
100, 120, 150, 180, 220, 250 (Hz)
Front High Pass Slope
-6, -12, -18, -24 dB/Oct
Rear High Pass Filter
Through, 30, 40, 50, 60, 70, 80, 90,
100, 120, 150, 180, 220, 250 (Hz)
Rear High Pass Slope
-6, -12, -18, -24 dB/Oct
Subwoofer Low Pass Filter
30, 40, 50, 60, 70, 80, 90, 100, 120,
150, 180, 220, 250, Through (Hz)
Subwoofer Slope
-6, -12, -18, -24 dB/Oct
Subwoofer Phase
Reverse (180°)/ Normal (0°)
(
: Factory setting)
Hide quick links:
Advertisement
Table of Contents
