Level Setting Using A Music Source; Changing The Input Mode - Kenwood DVR-605 Instruction Manual

56
Speaker setting

Level setting using a music source

A music source can be used for speaker level setting and subwoofer level setting.
1 Play a disc marked "Dolby Digital".
2 Select the speaker.
FRONT
3 Press the TRIM (5/∞) key to setting
the speaker level.

Changing the INPUT MODE

The input mode can be switched with SAT/CABLE and FRONT. For better sound quality, connect the digital output of
your component with a coaxial or optical cable and change the input mode as follows.
1 Select the SAT, CABLE or FRONT key.
SAT
or
2 Press the INPUT MODE key.
3
CENTER REAR
SW
5
TRIM
∞
CABLE
FRONT
or
AUX
INPUT MODE
RANDOM
Changing the INPUT MODE
Speaker level adjustment can be performed by
pressing the keys FRONT, CENTER, REAR, and SW.
F: Front speakers
Switching is done as follows each time the switch
is pressed.
1 L ch : Left speaker
2 R ch : Right speaker
C: Center speaker
R: Rear (Surround) speakers
Switching is done as follows each time the switch
is pressed.
1 LS ch : Left surround speaker
2 RS ch : Right surround speaker
SW: Subwoofer
The speaker level can be changed in the range from -10
dB to +10 dB.
When the video is displayed, but no sound is put
out, the source may not contain digital audio. In such
Note Note
a case, please switch to ANALOG.
÷ AUTO input mode only checks the input signal when the
INPUT is changed. The input does not automatically switch
from digital (optical/coaxial) to ANALOG when the digital
signal from the source component stops. In this case, use
the remote to select ANALOG input mode.
Each press switches the mode.
SAT/CABLE input
1 AUTO
2 COAXIAL
3 ANALOG
DVR-605/DVR-6100/DVR-6100K (EN)
FRONT input
1 AUTO
2 OPTICAL
3 ANALOG